PDA

View Full Version : m50/s50 conn rods


adrock1
01-24-2007, 11:26 AM
does anybody now which way they face when in staulin them. i'm havin a major brain cramp. i now the rods are not symetrical and should be installed in a certain fashion. and i now the #'s on the caps and rods have to match but not sure which way they face. any input would be great. thank you.

peerless
01-24-2007, 12:07 PM
I ran into a similair problem with my M20 rods as I was building it from a box of parts.

On the M20, the bearing notches are on the trailing side of the crankshaft. Think facing exhuast side. I am going to assume the m/s50 rods are similair.

My rods where also not numbered from the factory so it was kinda confusing to put together.

Hope this helps.